· Inserting a "right" or "middle" beam to the left of an existing beam group will

cause that note to attach itself to the beam on its right. Likewise "left" and "mid-

dle" beams will attach to the right of an existing beam. Clicking inside an existing

beam group with the "middle" beam selected will insert a beam note inside the

beamed group.

· Clicking on an yellow-highlighted beamed note will change its note value and/or

beam direction as indicated by the cursor.

· To delete a beamed note, Quick-Select it, hit the "X" key and clicking again to

remove it. Deleting an end beam will cause the beam to join to any adjacent

beamed groups.

5.2.11

Forming beam groups (Select + "B")

To create a single beam group from adjacent flagged or beamed notes:

· Use the Select tool ("O" key) and highlight any number of adjacent flagged notes.

Hit the "B" key to join the notes into a single beamed group. The "B" key will

also join two or more adjacent beam groups that are selected.

5.2.12

Barlines

a.  While in the Insert mode, hit the "I" key (or select any barline from the

"Barlines & Repeats" palette).

b.  Click anywhere in the active staffline to Insert a barline.

5.2.12a

Deleting / changing barlines at the end of systems.

Deleting a barline at the end or beginning of a system will cause that measure to roll

up or down to an adjacent system. Follow this step to delete or change a barline type

that ends or begins a system...

To change a barline at the end of a system to another barline type,

a.  Insert the desired barline type to the left of the barline that you wish to

remove.

Delete the barline ("X" key then click). The measure will shift slightly to the left but

not roll to an adjacent system.

5.3

ENF Symbol Properties

Using to SmartScore X